The Z-shaped angled Multi-Tech magnetic conveyor belts, type ZMF-LD 120, are individually adapted to the customer's specific application. Five different conveyor angles between 30° and 90° are available. This makes these conveyor belts ideal for transporting magnetic parts vertically upwards in the most space-saving way possible.

Medium-sized Z-shaped angled magnetic conveyor belts with total lengths of up to approximately 3,000 mm are often equipped with a type LD 120 base frame. It consists of a welded base frame on which two vertical and two rotating aluminum profiles are mounted, serving as supports for the conveyor belt. The profiles are attached with pivot points in the side grooves of the belt frame. This base frame design offers great stability and allows the installation of even heavier magnetic conveyor belts or additional attachments.

The lower flat belt section usually hangs freely and can thus be lowered to floor level or inserted into machine shafts in a suspended position. Longer flat belts are supported by additional belt supports.

Magnetic conveyors of this design are often used as machine discharge belts, as feeder belts for material in subsequent processes, or as linking belts between workstations.

The belt body of the angled magnetic conveyor, type ZMF-LD 120, consists of an aluminum profile system. The sturdy profiles each have a groove on the side and below the conveyor belt, which can be used for attaching base frames, drive units, sensors, and other attachments. This avoids complex drilling or welding work and ensures maximum flexibility.

Plastic slide rails are integrated into the conveyor body, in which two revolving chains are guided. Magnetic carrier rails are mounted at regular intervals on these chains, which run beneath a stainless steel slide plate integrated into the conveyor body. Ferritic material lying on the slide plate is attracted by the magnetic force and pulled along accordingly. Strong neodymium magnets ensure high holding force and good part grip.

The slide plates are available with a smooth or textured surface, depending on the application. Especially with oily parts, the structure ensures that adhesions are avoided and the parts are transported safely. If necessary, additional wear plates are mounted in the feed area of ​​the conveyed material.

Spring tensioners are integrated into the conveyor belt design to keep the chains under sufficient tension at all times, thus reducing adjustment and maintenance effort. The belt body is completely encapsulated, so there are no moving parts on the outside. This ensures maximum safety. on occupational safety.

The Multi-Tech ZMF-LD 120 magnetic conveyor belts are equipped with powerful three-phase motors, which can be adapted to the respective conveying task with different motor powers, gear ratios, and controls.