Our website uses cookies and similar technologies. If you click on "Accept", you allow us to store all types of cookies. You can adjust your personal settings by clicking on "Preferences". You can revoke or change your given consent at any time. For more information about our data processing please visit our Privacy Statement. If you have any further questions, please contact info@mtf-technik.de.

Preferences Accept

Please select your cookie settings

Save and Close

Belt Conveyor Type NL-LD 020

Belt Conveyor with Negative Angle

MTF Technik - Belt Conveyor Type NL-LD 020

Angled belt conveyor type NL-LD 020 in clean-room design. The belt conveyor is completely encapsulated and thus, can be used e.g. to convey plastic parts from the injection moulding machine to a clean-room. Apart from the belt with FDA-approval, the MFT provides a variety of equipment options in order to use the belt conveyors in clean-rooms.

MTF Technik - Belt Conveyor Type NL-LD 020

Angled belt conveyors with long steep belt and with usually a rather short flat belt part are often equipped with an underframe of type LD 020. In this case, the flat belt hangs over freely. The close base frame of the underframe gives the belt conveyor a safe standing - also with wider conveyor belts and higher belt loads.

With longer flat belts this part either rests on the floor or additional supports will be mounted - optionally stationary or mobile. Hence, in many cases these angled belts are used where lower feeding heights are required.

Typical application cases therefore are in e.g. the plastics industry, if the conveyor belt shall be set up longitudinally, next to the machine and the parts are fed onto the conveyor belt via a chute or a QS-diverter. Such angled belts are also used on packing machines, in the blanking and punching industry, as chipping and splints belt conveyor in machine tools or as feeding belt e.g. for grinders of granulated materials.

Product Information

Belt Conveyors Type NL

Highlights

Angled conveyors in L-shape are equipped with the underframe LD 020, if the flat belt part is to be lowered until the floor and at the same time, only very few underframe parts may protrude on the sides.

  • Stable standing due to closed underframe
  • Continuous height and incline adjustment
  • Freely overhanging flat belt part; can be supported additionally, if necessary

MTF Specialist

Do you need a customized offer?

Please find below Inquiry Forms for standard devices of Conveyor Technique, Separation and Automation in PDF-format.
Go to Inquiry Forms