The Z-shaped angled small conveyor belts of type IZL-IE 050 are the perfect helpers when it comes to conveying products out of narrow shafts or low loading heights, then transporting them upwards and depositing them into containers or similar. The low frame height of only 30 mm allows for the construction of conveyor belts with a total height of less than 80 mm. Z-shaped angled small conveyor belts with a total length of up to approximately 1,500 mm and a belt width of up to 300 mm can be equipped with the IE 050 type underframe if the conveyor belt is to be installed as freely suspended as possible to avoid sharp edges. The underframe consists of a sturdy, welded base frame with a vertically mounted support tube. The conveyor belt is mounted on one side of the support tube at its center of gravity and can be adjusted in height along the entire length of the tube. This allows for a maximum height adjustment range. This is particularly necessary when the conveyor belt is used on different machines and has to perform different tasks. A total of seven different conveyor belts made of PVC, PU, ​​or polyester material with various surface textures and properties are available for these conveyors. In addition to these belts from the MTF standard range, special types can also be fitted if required. The Z-shaped angled small conveyor belts type IZL-IE 050 can be equipped with three different drive units, which, in combination with various power outputs, gear ratios, and controls, ensure optimal adaptation to the respective transport task. Building on this basic configuration, the conveyor belts can be functionally expanded with a wide range of accessories. These include fans, radiant heaters, ionizers, covers, sensors, chutes, hoods, etc.